Justfog Minifit Pods

The Justfog Minifit Pods are easily placed using the click system! These pods are designed as replacements for the Justfog Minifit Starter Pod Kit. You can fill the pod from the bottom with your favorite e-liquid, place it on your Minifit battery, and start using it right away.

About the resistance

The Minifit pod is available in one resistance level. The pods are best suited for e-liquids containing a maximum of 60% VG.

1.6 ohm
With a resistance of 1.6 ohm and a capacity of 1.5 ml, the pods produce moderate vapor. The vapor production is similar to that of a traditional cigarette's smoke.

About the coil

The wire inside the pod is made of kanthal, which heats up quickly and provides a good flavor. With a resistance of 1.6 ohm, the pod is suitable for Mouth-to-Lung vaping. This means the inhaling method is similar to that of a traditional cigarette. If the flavor weakens or you experience a burnt taste, it's time to replace the pod. Typically, this occurs after 1 to 2 weeks of use.

About using Justfog Minifit Pods

The pods are packaged in sets of 3, providing approximately a month's supply. You can check the remaining e-liquid level by holding the pod against the light. Never vape with an empty pod, so make sure to refill it in a timely manner. To fill the pods, remove the pod from the Minifit or the packaging. At the bottom, you'll find a rubber stopper that can be pulled out. This is where you can fill the pod with e-liquid.

When replacing a pod, it's important to let the liquid soak in properly: Let the Minifit sit for 10 minutes after filling before using it.