Voopoo Uforce Coils

The Voopoo Uforce coils are powerful sub-ohm coils suitable for all variants of the Uforce clearomizer!

About the resistance

The Uforce coils are available in four different variants. For all coils, it is recommended to use e-liquids with a maximum VG (vegetable glycerin) content of 80% for optimal performance.

U2
The U2 coil has a resistance of 0.4 ohm. It is a parallel coil made of two Kanthal wires and organic cotton. The recommended wattage range is 40 to 80 watts, but it performs best between 55 and 65 watts.

U6
The U6 coil is a sextuple coil with three parallel coils and a resistance of 0.15 ohm. Like the U2 coil, it uses Kanthal wire and organic cotton. The U6 coil can be used between 65 and 110 watts, with the best performance between 80 and 90 watts.

N1
The N1 coil is a mesh coil. Instead of a wire, it utilizes a perforated piece of Kanthal, increasing the surface area in contact with the cotton for enhanced vaporization of e-liquid. The resistance of this coil is 0.13 ohm, and it can be used between 50 and 100 watts. The recommended wattage range is between 70 and 80 watts for optimal performance.

N3
The N3 coil is similar to the N1 coil but utilizes three mesh coils instead of one. It has a resistance of 0.2 ohm, and the wattage range for this coil is between 65 and 100 watts. For the best results, it is recommended to vape the coil between 75 and 85 watts.

About the coils

There are two different lines within the Uforce coils: the N-series and the U-series. The U-series uses traditional Kanthal coils in various configurations and resistances. The N-series utilizes mesh coils, providing a larger surface area in contact with the cotton. The Uforce coils use organic, unbleached cotton. Each coil typically lasts between 1 to 2 weeks.

Using the Voopoo Uforce Coils

Before using a coil, it is recommended to prime it. Apply a few drops of e-liquid to all the white cotton areas until most of the cotton is saturated. Then, fill your tank or clearomizer with e-liquid and let it sit for about five minutes to allow the liquid to fully absorb. Set your mod to the lowest wattage that the coil can handle (e.g., 40 watts for the U2 coil). After a few draws, gradually increase the wattage until you reach your desired wattage. Remember to refill your tank before it becomes completely empty, and avoid vaping with an empty tank to prevent dry hits.

By following these instructions, you can avoid burnt flavors and prolong the lifespan of your coil.